MR3020 Help. Cant SSH in!

So ive been trying to setup my box and having some trouble with the network bit. My router's ip is 192.168.1.1 so i was trying to make the MR3020 be 192.168.1.2 but that wasnt working so i THINK i made it 192.168.1.232 but i cant get into the device anymore! Please help D:

Edit:
Managed to get in and got all the way to where I was installing Pirate box. I plugged in my USB and the downloads started then they hung up for like 10 minutes. nothing was happening. So i figured Ohwell i'll just wipe the usb drive and try again. Now i cant SSH into the Box anymore again! i have the IP set to 192.168.1.111 and it was working fine. Now what do i do??



Edited 1 time(s). Last edit at 11/29/2012 02:27AM by Nitrodemon.

Hi,
try to boot your device in failsafe mode like described here: [github.com]

Check /etc/config/network
or directly start to reflash the device and make a complete new install-

If you have problems like this, you should save the output that I can found the reason for this issue

Hey,

I have a similar problem too. I have this same router and had everything working but I stupidly formatted the connected drive. Now the box doesn't work and I can't ssh or telnet to it, I had a working box for 30 minutes...

edit: Sorted it now, something wrong with my main router



Edited 1 time(s). Last edit at 12/06/2012 12:20PM by drob.

I am having a similar problem, can someone explain how I can re flash my mr3020 if I cannot ssh in?

Daniel,
if you are still having this issue then please check out GitHub.

Also there are some discussions about similar issues here on the forums, you can make a search and read to see of any of the help is applicable to your situation.